2010 nissan Altima
Catalytic Converter EPA Approved

This is a New MagnaFlow Exhaust Products Catalytic Converter EPA Approved (Note: New MagnaFlow EPA Approved Direct Fit HM Grade Catalytic Converter. 2.5L - Sedan). This Catalytic Converter EPA Approved is guaranteed to fit your 2010 nissan Altima. SKU number 45-45280-z6

Keep the check engine light off with MagnaFlow HM Grade Federal/EPA Compliant Direct-Fit Catalytic Converter 93257. With features including free-flowing mandrel-bent tubing and highly corrosion resistant stainless steel construction, easily install this spun body converter yourself using the proper tools, no cutting or welding required. MagnaFlow's state-of-the-art metrology department uses the latest 3D scanning systems during research and development, so you can be confident that your new part will fit and function like the original equipment. By replicating the OE spun body design, the single laser fusion weld greatly reduces the possibility of a leak, and our compact, low-mass design also allows for greater thermal efficiency. This direct-fit catalytic converter is designed specifically for the 2007-2018 Nissan Altima and interchanges with OE parts 20010-3TA2A and 20010-3TA3A, among others. Avoid potential exhaust leaks by using the included gaskets to get a proper seal. This replacement part is designed to meet or exceed Federal emissions requirements set forth by the EPA, complying with legal standards for OBDII Federally registered vehicles with Federal/EPA Emission systems.Body Type - Spun, Clamps Included - No, Finish - Stainless Steel, Universal Or Specific Fit - Specific, Grade Type - Regular, Tube Material - Stainless Steel, Hangers Included - Yes, Inlet Type - Bolt-On, Outlet Type - Bolt-On, Heat Shield Attached - No, Body Material - Stainless Steel, California Air Resources Board (CARB) Certified - No, Substrate Material - Ceramic, Inlet Gasket Included - Yes, Inlet Mounting Hardware Included - No, Outlet Gasket Included - Yes, Outlet Mounting Hardware Included - No, Overall Length - 49.75 in., Air Tube Count - 0, Sensor Port Count - 2, Oxygen Sensor Location - Pre and Post Converter, Air Tube Adaptable - No, CARB Executive Order Number - Not Applicable, Prop 65 Y/N - No, Series - HM Grade